Box Mount Kit (available on special request only)

This has the same construction as our Box Mount, but it comes with a pressure sensitive adhesive on the front so you can mount your own print. We can make any custom size and normally make about 3/8 inch undersize so you can mount a standard size print and have room to trim around the edge. We provide a knife for trimming. Watch the video below and read the instructions to see how easy it is.

Construction

Box is made from 1/4-inch-thick MightyCore panel which has an acid-free paper on front and back with an inert core. Your print will stay flat up to a maximum size 32x44 inches. It comes with a hanging wire that will adjust for either portrait or landscape orientation. The reinforced corners are flush with the back to hold provided glue dots for keeping it straight on the wall. The pressure-sensitive adhesive is protected by a release paper and will make a permanent bond in a short time. Although it is possible to trim your print to the right size before attaching to the front, it is hard to align exactly for large prints and so it is better to make oversize and trim after mounting.

How to order

Order based on your print size including bleed necessary for trimming. We will make 3/8 inch smaller (3/16 inch all around) unless you request otherwise. Depth out from the wall can range from 1 to 4 inches. Discounts apply if you order several of the same size.