Cleaning your prints

All of our prints have a protective coating that is water and abrasion resistant. Since they do not have a glass cover, you will have to clean them occasionally. Although you should not try this, we have tested our prints by pouring coffee on them, allowing it to dry, then holding them under the faucet to clean with soap. When done there was no stain apparent on the print. The only way we have damaged a print is to leave it soaking in water for an extended period. In this case the water penetrated into the foam board paper surface from the side and the print, still looking good, became detached from the mounting board.

Cleaning instructions (also on back of print)

Don’t touch the print surface with your fingers or a hard object.  First dust with a clean dry cotton cloth or clean soft brush.  If you use a brush, first wash the brush with soap and water then allow to dry.  After dusting, wipe the print surface with a clean damp cotton cloth.  Best to use distilled water.  Do not use any soap or cleaning agent.